Getting The Best Swim Spa Cover

Swim Spas represent distinct challenges when it pertains to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot harder.
Getting a new swim spa is an exciting occasion in life. You’re eagerly anticipating the exercise you’ll receive from using it. Possibly you’re a little relieved to have actually lastly selected from the different designs you looked at. At any rate, you most likely weren’t believing much about the cover you would use.
Typically, the cover that comes home with your new purchase will be a four section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence since as quickly as it is put in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper will not make any difference. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are really small as they rise from the water surface area. They make their way into the little fractures and crevices in the foam.

Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It happens slowly and on a Swim Spa Cover which is made from individual areas, at differing speeds. So eventually you’ll see one or two of the areas are truly getting heavy. The bar lifters on the ends of the swim spa aren’t much aid since you still have to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com came up with a different design for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will eventually wind up in some land fill, they developed one that utilizes air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or break down at the joints either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the cover for it.
If you’re not all set to buy today, bookmark this website so you can discover it again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *